Zirconium silicate ball zirconia beads are firstly made of micron-sized and sub-nano-sized raw materials, and are made by advanced technology. The technical indexes and performances have reached the international advanced level. Zirconium silicate ball is mainly used in ultral industry. High grinding efficiency: Due to the high density of zirconium beads, it has a higher grinding kinetic energy at the same moving speed, and the grinding efficiency is 2-3 times higher than that of ordinary ceramic beads. You can get better results. Impact resistance, low wear: Due to the high content of ZrO2, it has the advantages of high density, high toughness, low abrasion, no broken ball, peeling, etc., and it has little pollution to the abrasive dispersion. The abrasion is 4-10 times lower than that of ordinary ceramic beads....
2019/05/29 Zhao jinliang 14
Mirror surface grinding: At the same time, it is necessary to consider both surface roughness and dimensional accuracy. Processing speed is not a priority. Mirror polishing: At the same time, it is necessary to balance the surface roughness and processing speed. The dimensional accuracy is not a priority....
2019/05/22 admin 14
the biggest problem is that the rubber will cause the porous of the grinding wheel to block. Once the porous are blocked, the grinding temperature will increase. In addition to the loss of the cutting force of the grinding wheel, the surface of the rubber will also dissolve, and further cause undesirable conditions such as uneven surface, burrs and even cracks. ...
2019/05/22 Zhao jinliang 11
abrasive material chooses cast iron sand with a particle size of 0.5mm~1.5mm. Abrasives are required to be angular, clean, dry, and free of oil; 2 injection treatment of all compressed air through the cooling device and oil water separator to ensure that the compressed air is dry, oil-free, compressed air pressure is 0.7MPa; 3 nozzle to the base metal surface to maintain a distance of 100mm~300mm; 4 nozzle orifice diameter increases due to wear, need to be replaced when its diameter increases by 25%; The angle between the spray direction and the normal of the base metal surface is controlled at 15~30. Within the scope....
2019/05/22 Zhao jinliang 12
The grain size of abrasives applied in blasting Below standard should be followed for mostly sand blasting material, for example brown fused alumina, white fused alumina, pink fused alumina, black silicon carbide, green silicon carbide... Steel grit and steel shots , glass beads, ceramic beads will be other specifications according with standard or client's requirements....
2019/05/22 Zhao Jinliang 22
Abrasive grains and powder for use in the manufacturing of bonded abrasivesThe following data sheets are a compilation of the useful chemical and physical properties of the abrasive grains and powders...
2019/05/22 Zhao Jinliang 12
Grinding Wheel Static Balance Testergrinding wheel static balance tester can be used to narrow flat type (D/H ≥ 5)parallel wheel for stat...
2019/05/22 Zhao jinliang 20
Double taper wheel countercurrent mixer It is known as the wheel mill, is com...
2019/05/22 Zhao jinliang 16
